
5-10
Operation Manual
■
Deleting measurement results
Press the Clear button on the control panel.
■
Printing measurement results
Press the Print button on the control panel.
■
Exiting basic measurements
Press the Caliper button again on the control panel. Or press the Exit button.
NOTE: To change settings such as measurement units, tap Utility on the touch screen and select
Measure Setup > General. For more information, please refer to Chapter 7 “Utilities”.
[Figure 5.1 Caliper]
NOTE: The displayed measurement results vary depending on the settings in Utility > Measure
Setup > General > Caliper.
Comentarios a estos manuales