
4-13
Chapter 4 Diagnosis Modes
■
U/D Flip (Up / Down Flip)
Tap the up and down flip icon on the touch screen.
The image flips up and down each time this button is pressed.
■
L/R Flip (Left / Right Flip)
Tap the left and right flip icon on the touch screen.
The image flips left and right each time this button is pressed. The M mark at the top of the image
indicates the present direction of the image.
■
Change Window
NOTE: Change Window is available only in the 2D menu of Dual mode.
Tap Change Window on the touch screen. Each time you tap this button, the position of the image
being scanned is altered to the left or right. The image being scanned is outlined in yellow at the
top of it.
■
Top-Bottom Dual
Tap Top-Bottom Dual on the touch screen. The left and right display is changed to top and bottom
display in Dual mode.
■
View Angle
Tap View Angle on the touch screen. Adjust the image angle by tapping a desired button or using
the dial-button on the touch screen. The button is enabled only when Scan Area is less than 100%.
■
Scan Area
Tap Scan Area on the touch screen. Select the width of an image between 40 and 100 by tapping
a desired button or using the dial-button on the touch screen. Increasing the image width reduces
the frame rate.
NOTE: View Area varies depending on the preset.
Comentarios a estos manuales