Samsung AVXTJ series Guía de instalación descargar pdf (Pagina 95)

Installation guide

1-2. Installation Steps

Sleeve work should be performed to make a space for passing pipe and wire through the wall or

ground under construction.

① Place the pattern sheet on the ceiling at the spot where you want

to install the indoor unit.

 Since the diagram is made of paper, it may shrink or stretch

slightly due to temperature or humidity. For this reason, before

drilling the holes maintain the correct dimensions between the

markings.

② Insert bolt anchors, use existing ceiling supports or construct a

suitable support as shown in figure.

③ Install the suspension bolts depending on the ceiling type.

※ Ensure that the ceiling is strong enough to support the weight

of the indoor unit. Before hanging the unit, test the strength of

each attached suspension bolt.

 If the length of suspension bolt is more than 1.5m, it is

required to prevent vibration.

④ Screw eight nuts to the suspension bolts making space for

hanging the indoor unit.

※ You must install the suspension bolts more than four when

installing the indoor unit.

⑤ Check the level of the indoor unit by using a leveler. A tilt of the

indoor unit may cause malfunction of a built-in float switch and

water leaks.

⑥ Adjust the height of the indoor unit by using the gauge of

dimensions.

 You should adjust the gauge of dimensions and the pattern

sheet to fit the cutting dimensions of ceiling.

 Make sure that the indoor unit is installed at a level if the

indoor unit slants too much, there can be water leaks.

⑦Tighten the upper part nuts

⑧ Remove the gauge of dimensions after installing the indoor unit.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 136 137

Sin comentarios

Samsung AVXTJ series Guía de instalación Pagina 95