Samsung SONOACE R3 Manual de usuario descargar pdf (Pagina 120)

Operation Manual

4-34



■

Magnication

To magnify or reduce the image size, enter Magnication mode by pressing the Magnication button,

and move the Trackball right or left. After checking changed values in the Preview screen, apply the

changes to the entire screen by pressing the Softmenu button [4] Apply.

Pressing the Exit button applies the changes to the 3D image and exits the Magnication mode.

To activate the Rotation, Position or Cut Mode function while adjusting the image size, press the

corresponding Softmenu of each function. To return to the initial image, press the Softmenu button [5]

INIT 3D.

[Figure 4.14 Softmenu – Magnification Mode]



■

Cut Mode

Press the Cut Mode button on the left side of the screen to enter Cut mode. Determine the area to cut

using the trackball, and press the Set button. Then, the “+” cursor appears. After contouring the area to

cut, press Set button again, and the cutting is nished. To cancel the cutting area, press the Exit button.

Press the Softmenu button [1] Inside Contour to outline an area to be cut. The Softmenu button [2]

Point Eraser function is used to cut a portion of the image. The default setting is Inside Contour.

To cancel cutting, press the Sofmenu button [3] Undo. To redo the cancelled job, press the Softmenu

button [4] Redo.

To cancel all cuttings and return to the initial 3D screen, press the Sofmenu button [5] Undo All.

[Figure 4.15 Softmenu – Cut Mode]

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 290 291

Sin comentarios

Samsung SONOACE R3 Manual de usuario Pagina 120