Samsung MYSONO U6 Manual de usuario descargar pdf (Pagina 185)

5-11

Chapter 5 Measurements and Calculations

Distance Measurement

Distance

This is a basic measurement that is available in all diagnosis modes. You can specify two points in a 2D

image and measure the straight distance between them.

1. Press Caliper and select Distance under soft menu [1]. ‘Distance’ is shown in the user information

area.

2. Use the trackball and the Set button to designate the two end points of the measurement area.

X

Use the trackball to place the cursor at the desired position and press the Set button.

Tips!

Repositioning Point

Instead of pressing the Set button to confirm the point position, you can press the Change button

to reset it.

3. Specify both end points and then the distance between them will be measured.

4. When the measurement is nished, its result is shown on the screen.

Line Trace

This is a basic measurement that is available in all diagnosis modes. You can specify a point in a 2D

image and trace a curve from that point to a second point on the image. You can then measure the

distance between the two points.

1. Press Caliper and select Line Trace under soft menu [1]. ‘Line Trace’ is displayed in the user

information area.

2. Use the trackball and the Set button to specify the starting point of the measurement area.

X

Use the trackball to place the cursor at the desired position and press the Set button.

3. Use the trackball to draw the desired curve and then press the Set button to set the end point.

Tips!

Editing Curves

Before specifying the end point by pressing the Set button, you can delete part of the curve being

traced by rotating the [5] Delete dial-button on the soft menu.

4. Specify both end points, and then the length of the curve will be automatically measured.

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 281 282

Sin comentarios

Samsung MYSONO U6 Manual de usuario Pagina 185