Samsung MYSONO U6 Manual de usuario descargar pdf (Pagina 119)

4-11

Chapter 4 Diagnosis Modes

 SRF

SRF is an acronym for Speckle Reduction Filter.

NOTE: SRF is not available if DMR+ is turned on.

Press the soft menu dial-button [6] to optimize an image by minimizing noise and adjusting the

brightness of boundaries automatically. Turning SRF on by pressing the dial-button displays

mark on the right side of the screen and creates the SRF Index option in the soft menu.

 SRF Index

This option only appears in the soft menu when SRF is turned on. Two predened indexes are

available. Select between 1 and 2 by rotating the [6] dial button beneath the soft menu.

 Ext. Res.

Press the soft menu dial-button to turn Ext. Res. on or o. When turned on, this function increases

the number of channels and consequently the resolution. However, the frame rate decreases in this

case. Ext. Res. is an abbreviated form of extended resolution.

 Scan Area

Used to specify the image width. Set to a value between 40% and 100% by pressing the soft menu’s

dial button. Increasing the image width reduces the frame rate.

 2D Image Size

Used to specify 2D image size. Set to a value between 80 and 100 by rotating the soft menu’s dial

button.

 FSI

Synthesizes the images using data measured at dierent frequencies in 2D mode. Shallow

observation depths yield higher resolution and deep observation depths yield higher penetration.

Select between 1 and 3 by rotating the soft menu’s dial button. FSI is an acronym for Full Spectrum

Imaging.

 Gray Map

Changes the Gray Map. Set to a value between 1 and 13 by rotating the soft menu’s dial button.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 281 282

Sin comentarios

Samsung MYSONO U6 Manual de usuario Pagina 119