
Operation Manual
5-22
■
Changing Measurement Method
Press the Change button. If the current measurement item can be measured in more than one way,
the measurement method is changed. The current measurement method is displayed in the user
information area. Once measurement is started, it cannot be changed.
■
Setting Measurement Result Display
Use the dial-buttons for the soft menu.
[Figure 5.2 Soft Menu for Measurement by Application]
X HR Cycle: This becomes enabled when measuring heart rate in M/D Mode. This is for setting
heart rate cycles for the set time period. You can select between 1 and 20.
X Threshold: This becomes enabled only after performing Auto or Limited Trace in Spectral
Doppler Mode. Adjusting the Threshold value helps performing contour on the Doppler
spectrum.
X Menu View: Specify whether to show measurements in the measurement menu.
[Item + Value]: Show measurement items and their values.
[Item Only]: Show measurement items only.
X Result Action: Set the position for measurement results.
[Move]: Change the position where measurements are shown. Use the trackball to change the
location and then press the Set button.
NOTE: When measurement results are displayed in more than one screen because there are too
many of them, use Move to browse through the desired measurement results.
[Reset]: Press the dial-button to reset the display location of measurement results.
X Delete: This becomes enabled during Trace measurement. Turn the dial-button to delete a part
of the curve being traced.
X Undo: Undo the most recently performed measurement.
Comentarios a estos manuales