
30) Install the remaining end cap and two screws. Make sure the end cap sits flush with the rest of the cartridge. See
Figures 34 & 35
31) Replace the fuse located on the right front of the cartridge (with the handle away from you. Start cartridges do not have
a fuse at all, but the holding tabs are there. The fuse is a 63mA 250V fast acting 5 x 20mm glass type. See Figure 36
z Toner approved vacuum
z A small Common screw driver
z A Phillips head screwdrive
Figure 32 Figure 33
Figure 34 Figure 35
Figure 36
TOOLS REQUIRED
Page 8 of 9SUMMIT TECHNOLOGIES
4/21/2008htt
://www.summitechnolo
ies.com/docs/0365/0365.as
Comentarios a estos manuales