Samsung ML-1610 - B/W Laser Printer Manual de usuario

z Publications { Dealer Catalog #23 { Catalog Update z Chips { Comprehensive Chip List { Lexmark Chip Cross Reference { Reset Box Information  Sa

These cartridges are based on a completely new engine/cartridge design. The cartridges have a huge handle that folds over the cartridge when installed

3) On the front edge of the cartridge, there are two screws, remove them. See Figure 6 4) Lift up and remove the waste chamber from the cartridge. Mak

9) Remove the 4 gears, and place aside. See Figure 12 10) Slide the PCR away from the contact side, lift up and remove. See Figure 13 Clean the PCR

14) Gently pry out the roller plate from the cartridge by pressing in on a tab located on the bottom of the cartridge. There is a sprint that is in c

18) Clean the feed roller and any remaining toner from the hopper. See Figure 20 19) Re-install the doctor blade and two screws. Make sure the tail of

25) Clean out the old conductive grease from the PCR contact hub and replace with new. A small amount of grease is fine, more is not better when it co

30) Install the remaining end cap and two screws. Make sure the end cap sits flush with the rest of the cartridge. See Figures 34 & 35 31) Replace

z Needle Nose Pliers Repetitive Defect Chart PCR 38mm Developer Roller 44mm OPC Drum 75mm A Dirty or Bad Primary Charge Roll