Samsung HS50 Manual de usuario descargar pdf (Pagina 157)

8-13

Chapter 8 Measurements and Calculations

Distance Measurement

 Distance

This is a basic measurement that is available in all diagnosis modes. Specify two points on a 2D

image and measure the length of the straight line between the points.

1. Select Distance on the monitor or touch screen. Use the trackball and the Set button on the

control panel to specify the end points of the measurement.

Use the trackball to place the cursor at the desired position and then press the Set button.

Tips!

Repositioning a Point

Instead of pressing the Set button to conﬁrm the point position, you can press the Change button

to reset it.

2. Specify both end points and then the distance between them will be measured.

3. When the distance has been measured, the result is shown on the screen.

 Trace Length

This is a basic measurement that is available in all diagnosis modes. Specify a point on a 2D image

and trace a curve from that point to measure its length.

1. Select Trace Length on the monitor or touch screen. Use the trackball and the Set button on

the control panel to specify the start point of the measurement.

Use the trackball to place the cursor at the desired position and then press the Set button.

2. Use the trackball to draw the desired curve and then press the Set button to set the end point.

3. Specify both end points and then the length of the curve will be measured.

Tips!

Editing Curves

Before specifying the end point by pressing the Set button, you can delete part of the curve being

traced by rotating the soft menu dial-button 5 counter-clockwise. To restore the deleted curve,

rotate the dial-button clockwise.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 281 282

OSCAR 23 Apr 2025 | 08:21:36

Samsung HS50 Manual de usuario Pagina 157