
Chapter 4 Diagnosis Modes
4-5
■
Zoom
Press the Zoom button on the control panel to start Read Zoom mode. This function allows you to
zoom an image saved in a hard disk.
In HD Zoom mode, it is available to press the Zoom button on the control pane to start the Read Zoom
mode. However, in Read Zoom mode, you cannot enter the HD Zoom mode.
1. Press the Zoom button on the control pane.
2. Use the Trackball to move the Zoom box. You can locate the Zoom box in an image with the Zoom
Navigation box on the left side of the screen.
Tips!
Zoom Navigation Box
You can view the position of the magnified area through the Zoom Navigation Box on the screen.
Use the Change button to move and resize the Zoom box. Each time you press the Change button,
the current state of the Zoom box is displayed in the screen.
X
RZ Pos.: You can move the Zoom box. Use the trackball to move the Zoom box and press the Set
button to specify its position.
X
RZ Size: You can resize the Zoom box. Use the trackball to resize the Zoom box and press the Set
button to specify its size.
3. View the magnied image.
4. To exit zoom mode, press the Zoom key again or press the Exit button. Changing the depth also
exits Zoom Mode automatically.
■
QuickScan
Use the Q Scan dial-button on the control panel. The ‘Q Scan’ mark will appear at the top of an image.
In 2D Mode, it is used to optimize the contrast and brightness of an image by adjusting Gain and TGC
automatically. In PW Spectral Doppler Mode, it is used to optimize the spectrum by adjusting Scale and
Baseline automatically. Press the Exit button to quit the Quick Scan Mode.
Comentarios a estos manuales