Samsung SONOVET R5 Manual de usuario descargar pdf (Pagina 116)

4-34

Operation Manual

■

Magnication

To magnify or reduce the image size, enter Magnication mode by pressing the Magnication button,

and move the Trackball right or left. After checking changed values in the Preview screen, apply the

changes to the entire screen by pressing the Softmenu switch [4] Apply.

Pressing the Exit button applies the changes to the 3D image and exits the Magnication mode.

To activate the Rotation, Position or Cut Mode function while adjusting the image size, press the

corresponding Softmenu switch of each function. To return to the initial image, press the Softmenu

switch [5] INIT 3D.

[Figure 4.14 Softmenu – Magnification Mode]

■

Cut Mode

Press the Cut Mode button on the left side of the screen to enter Cut mode. Determine the area to cut

using the trackball, and press the Set button. Then, the “+” cursor appears. After contouring the area to

cut, press Set button again, and the cutting is nished. To cancel the cutting area, press the Exit button.

Press the Softmenu switch [1] Inside Contour to outline an area to be cut. The Softmenu switch [2]

Point Eraser function is used to cut a portion of the image. The default setting is Inside Contour.

To cancel cutting, press the Softmenu button [3] Undo. To redo the cancelled job, press the Softmenu

switch [4] Redo.

To cancel all cuttings and return to the initial 3D screen, press the Softmenu button [5] Undo All.

[Figure 4.15 Softmenu – Cut Mode]

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 167 168

Sin comentarios

Samsung SONOVET R5 Manual de usuario Pagina 116