Samsung UM 20A1(B1)E3 Guía de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 166
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Spartan-3E FPGA Starter Kit Board User Guide www.xilinx.com 15
UG230 (v1.2) January 20, 2011
R
Chapter 2
Switches, Buttons, and Knob
Slide Switches
Locations and Labels
The Spartan
®
-3E FPGA Starter Kit board has four slide switches, as shown in Figure 2-1.
The slide switches are located in the lower right corner of the board and are labeled SW3
through SW0. Switch SW3 is the left-most switch, and SW0 is the right-most switch.
Operation
When in the UP or ON position, a switch connects the FPGA pin to 3.3V, a logic High.
When DOWN or in the OFF position, the switch connects the FPGA pin to ground, a logic
Low. The switches typically exhibit about 2 ms of mechanical bounce and there is no active
debouncing circuitry, although such circuitry could easily be added to the FPGA design
programmed on the board.
UCF Location Constraints
Figure 2-2 provides the UCF constraints for the four slide switches, including the I/O pin
assignment and the I/O standard used. The PULLUP resistor is not required, but it defines
the input value when the switch is in the middle of a transition.
Figure 2-1: Four Slide Switches
UG230_c2_01_021206
LOW
HIGH
SW3
(N17)
SW2
(H18)
SW1
(L14)
SW0
(L13)
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 165 166

Comentarios a estos manuales

Sin comentarios