Samsung AJ24FBADEC/SP Manual de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 47
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
Fixing the installation plate
You can select the direction of the drain hose depending on where you want to install the indoor unit. Therefore before xing
the installation plate to a wall or a window frame, you must determine the position of the 65mm hole through which the cable,
pipe and hose pass to connect the indoor unit to the outdoor unit.
Whenfacingthewall,thepipeandcablecanbeconnectedfromthe:
A
C
B
D
D
Direction of pipe
1. Determine the position of the pipe and drain hose hole as seen in the picture and drill the hole with an inner diameter
of 65mm so that it slants slightly downwards.
• Makesuretodrillonlyoneholeafterchoosingthe
direction of the pipe.
(Unit:mm)
Model A B C D

09/12

36 120 81 36

18/24

33 110 110 33
•Right(A)
•Left(B)
•Underside_right(C)
•Rear_rightorleft(D)
B
A
D
C
B
A
D
C
Pipe hole (Ø65 mm) Pipe hole (Ø65 mm)
Wall
<20mm
Plastic
Anchor
2. Fix the indoor unit.
If youx the indoor unit on a wall
(1) Fix the installation plate to the wall giving attention to the weight of the indoor unit.
If youx the indoor unit on a window frame
(1) Determine the positions of the wooden uprights to be attached to the window frame.
(2) Attach the wooden uprights to the window frame giving attention to the weight of the indoor unit.
(3) Attach the installation plate to the wooden upright using tapping screws.
If youx the indoor unit on a gypsum board
(1) Use stud nder to nd out locations of the studs.
(2) Fix the plate hanger on two studs.
• Ifyoumounttheplatetoaconcretewallusingplasticanchors,makesurethatgaps
between the wall and the plate, created by projected anchor, is less than 20mm.
• Searchforotherspotsiftherearelessthantwostuds,orthedistancebetweenthestudsaredierentfromthe
plate hanger.
• Fixtheinstallationplatewithoutincliningtooneside.
• Makesurethatawallcanwithstandtheweightoftheproduct.Ifyouinstalltheproductinaplacewhereitisnot
strong enough to withstand the product weight, the unit could fall and cause injury.
English-32
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 46 47

Comentarios a estos manuales

Sin comentarios