Samsung GN7A2IFXD Manual de usuario descargar pdf (Pagina 13)

Gas Connection

■ This appliance must be installed and connected in accordance with installa-

tion regulations in force in the country in which the appliance is to be used.

■ This appliance is supplied to run on natural gas only and cannot be used on

any other type of gas without modication. Conversion for use on LPG and

other gases must only be undertaken by a qualied person.

■ Connection with a rigid pipe made from copper and with

screw-on mechanical connectors.

Make the connection directly to the end of the elbow tted on

the appliance.

■ Connection using exible undulated metal tube with

screw-on connectors. (Fig. A)

You can use a exible stainless steel pipe available from your

after sales service department.

■

Connection using exible tube with screw-on connectors.

(Fig.B)

These tubes must not exceed 2 meters in length and must be

accessible along their entire length.

■ A full operational test and a test for possible leakages must be carried out

by the tter after installation.

■ Access to the whole length of the connection hose must be possible and

the gas hose must be replaced before its use before the end of service life

(indicated on the hose)

Elbow

The gas inlet connection tting is 1/2 inch female thread.

Gas distributed by pipe ; natural gas, propane-air gas or butane-air gas

For your safety, you must choose from the three following connection option.

■ For the user’s safety, we advise the connection to be made

with a rigid pipe if this is possible, using a exible undulated

metal tube with scerw-on connectors (maximum length

2meters) (Fig.A)

■ For an existing installation, where it is not possible to t a

reinforced, braided, exible gas hose, the connection can be

made with a exible gas hose (maximum length 2meters),

with two clamps.

One on the connector, and the other on the pressure

regulator, and a gasket should be tted between the

connector and the hob’s elbow. (Fig.B)

Elbow

Gas supplied by tank or cylinder (butane/propane)

■

You can obtain the connector and the gasket from your After-Sales Service.

In France, you must use a tube or a pipe featuring the “NF Gaz” logo.

If the installation is difcult, unscrew the Elbow slightly and tighten it after

locating the Elbow.

Fig.A Fig.B

Fig.A

Fig.B

Gasket

Connector

Clamp

Electrical Connection

■ This appliance must be earthed.

■ This appliance is designed to be connected to a 220~240V, 50/60Hz AC electricity supply.

■ The wires in the mains lead are coloured in accordance with the following code ;

- Green/yellow = Earth

- Blue = Neutral

- Brown = Live

■ The wire which is coloured green and yellow must be connected

to the terminal which is marked with the letter E or by the earth

symbol.

■ WIRING DIAGRAM

①②



MICRO SWITCHES



IGNITER

(INPUT: 220V 50~60HZ, OUTPUT: 15.25V)

BLUE TO NEUTRAL

GREEN & YELLOW TO EARTH

BROWN TO LIVE

GND

CONNECTOR

Ignition

Electrode

GND

GREEN TO EARTH

1 2 ... 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Samsung GN7A2IFXD Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Samsung GN7A2IFXD