E-6
PREPARING THE INSTALLATION
Accessories
The following accessories are supplied with the air conditioner.
➢ The number of each accessory is indicated in parentheses.
Accessories in the Indoor Unit Case
Accessories in the Outdoor Unit Case
Installation Plate (1) Remote Control (1)
Batteries for
Remote Control (2)
User’s Manual (1) Installation Manual (1)
➢ The flare nuts are attached to the end of each pipe of an evaporator or a service port.
Use the nuts when connecting the pipes.
➢ The (2)3-wire assembly cables are optional. If they are not supplied, use the standard cable.
➢ The drain plug and rubber leg are only included when the air conditioner is supplied
without the assembly pipe as seen in the picture below.
The following connection accessories are optional. If they are not supplied, you should prepare them
before installing the air conditioner.
➢ If these accessories are supplied, you can find them in the accessory box.
Pipe Clamps B (3) M3.8 x 20 Wood
Screws (10)
Putty 3.28oz(100g) (1)
M4 x 16 Tapping
Screws (10)
Drain Hose,
length 6.56ft(2m) (1)
Pipe Clamps A (3)
PE T3 Foam Tube
Insulation (1)
Rubber Leg (4)Vinyl Tape (1) Drain Plug (1)
3-wire
Power Cable (1)
2-wire
Assembly Cable (1)
3-wire
Assembly Cable (1)
Drain Plug (1) Rubber Leg (4)
Assembly Pipe,
Ø inch(6.35mm) (1)
1
4
Assembly Pipe,
Ø inch(12.70mm) (1)
(✴✴18✴✴)
1
2
Assembly Pipe,
Ø inch(15.88mm) (1)
(✴✴24✴✴)
5
8
Comentarios a estos manuales