Samsung SF-5100P Guía de usuario descargar pdf (Pagina 149)

7.6

Troubleshooting

Problem Possible Cause and Remedy

Scan error occurs. Turn the printer off and back on. If you

still have the same problem, restart your computer.

Scan error occurred and the scanning has not been

completed properly. Reset your computer.

Re-install the MFP driver. See page 1.4. If you still have the

same the problem, file setting required for I/O may not be

proper. Follow the instructions below :

1. Start your Windows.

2. In Windows 95/98, select Run from Start menu.

3. Type ‘sysedit’, then click OK.

4. Select SYSTEM.INI file, and set the file as shown below.

[386 Enh]

device=vecp.386

LPT1TurnAroundDelay = 50

5. Restart your Windows.

I/O error occurs during scanning. Check for bad cable and

the cable connection. If you still have the same message,

open the System.ini file in the Windows directory as

described above, and increase time as much as required in

increments

of 10.

‘Scanning has failed. Restart

your scanner and try again’

message appears on the

screen.

‘The selected port is

currently being used.

Restart your computer and

try again’ message appears

on the screen.

‘The scanner driver is not

installed or an operation

environment is not set up

properly. Re-install the

scanner driver and try

again’ message appears on

the screen.

‘Port is disabled. Check if

the port is properly

connected, or power is on.

Then restart your computer’

message appears on the

screen.

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 155 156

Comentarios a estos manuales

Sin comentarios

Samsung SF-5100P Guía de usuario Pagina 149

Comentarios a estos manuales

Relacionado con productos y manuales para Software Samsung SF-5100P