Samsung SRP-275 Manual del operador descargar pdf (Pagina 22)

3-193-18 3-19

If you need to change settings, follow the steps below to make your changes.

1) Make sure the printer is turned off.

2) Remove the screw from the DIP Switch cover.

Then take off the DIP Switch cover, which is shown in the illustration below.

3) Set the switches using a pointed tool, such as tweezers or a small.

4) Replace the DIP Switch cover. Then secure it with the screw.

3.3 Changing the DIP Switch setting

Turn off the printer before removing the DIP Switch cover to prevent an electric short,

which can damage the printer.

The new settings take effect when you turn on the printer.

Switch settings

CHAPTER 3

Memory Switch 4

Bit Function 0 1

F~9

7~4

2~1

Automatic status function

ESC RS a n command function

Data reception error (serial)

Disabled

Only setting

Prints "?"

Enabled

Auto-status sent only once

Ignored

Memory Switch 5

Bit Function 0 1

F~0 Reserved

Memory Switch 6

Bit Function 0 1

F~A

8~0

BUSY Condition Reception Buffer or Offline Reception Buffer Full

Memory Switch 7

Bit Function 0 1

F~0 Reserved

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 109 110

Sin comentarios

Samsung SRP-275 Manual del operador Pagina 22