Samsung SPH-I300 Manual de usuario

Owner’s ManualHANDS-FREE CARKITFor use withSamsung phonesSPH-I300 & SCH-I300Samsung Telecommunications America1130 E. Arapaho Rd.Richardson, TX 75

8,QVWDOOLQJWKH+DQGVIUHHPLFURSKRQH1. Connect the microphone’s connector jack to the ‘MIC’ terminal on the Hands-free box.2. Install the microphone

9,QVWDOOLQJWKHH[WHUQDOVSHDNHUThe speaker is generally installed on the the passenger’s seat side.Note: Do not place the speaker near the microphon

10there may be a fuse box location for a cellular phone. Consult your vehicle owner’s manual. The red wire has an in-line fuse holder. Be sure to use

11Using the Hands-free Car Kit&DOLEUDWLRQThe Hands-Free Car Kit needs to be set for the optimum calling condition.1. Preparation for calibration•

12Note: If calibration is performed correctly, loud static and a single beep will be heard from the speaker. This indicates that the calibration was

134. Enter the phone number. If the other party answers, begin the conversation.• You can speak using the Hands-free microphone and hear your caller t

14%DWWHU\FKDUJLQJTo charge the phone’s battery you must do one of the following:• Keep your car running (recommended)• Make sure the ignition switch

15Using Voice DialTo use Voice Dial, you need to “train” the phone to recognize your voice. You can put up to 20 names from your Address book into you

167UDLQLQJWKH+DQGVIUHH&DU.LWTo train the Hands-free Car Kit for Voice Dial:1. Train the phone for Voice Dial in Hand-held mode, as specified

17• If the name is not recognized, the name is asked for again.• If the name is not recognized after two attempts, a message is displayed that says “C

7DEOHRI&RQWHQWVUnpacking... 2Installation ...

180DQDJLQJ\RXU9RLFH'LDO/LVWYou can play the recorded name, re-record the name, or erase the recording.Play or Record:1. From the Phone Menu,

198. Tap “Done” to save. Notice that there is a Voice Dial icon next to the drop down arrow. This indicates that the entry has Voice Dial enabled.9. T

20TroubleshootingThe phone does not turn on, even though the Hands-free Car Kit is connected to it.• Check that the power cable of the Hands-free Car

1Please read this manual before operating yourphone, and keep it for future reference.Please read this guide before you use this equipment.This owner’

2UnpackingExternal speakerHands-free microphonePower cableMounting bracketHands-free boxCradleMounting clamshellI300handsfree.book Page 2 Wednesday,

3Installation,QVWDOODWLRQQRWHV• The installing location should provide both clear visibility of the phone LCD display and keypad and unobstructed acc

4+DQGVIUHH&DU.LWFRQQHFWLRQGLDJUDP,QVWDOOLQJWKHFUDGOH1. Choose a suitable mounting location.• The Hands-free Car Kit and connecting cables m

54. Put the cradle on the lower clamshell. Adjust the mounting angle, and tighten the two large slotted screws.,QVWDOOLQJWKH+DQGVIUHHER[1. Choose

63. Attach the Hands-free box to the mounting bracket by snapping the box onto the bracket.Veh icleMounting bracketHands-free boxI300handsfree.book P

7&RQQHFWLQJWKHFUDGOHWRWKH+DQGVIUHHER[1. Connect the data cable on the cradle to the ‘DATA’ terminal on the Hands-free box.1I300handsfree.bo