Samsung Version 1.1 Manual de usuario descargar pdf (Pagina 19)

Connecting to PAN/TILT/ZOOM/FOCUS Controller

The RX/TX terminal of the reverse side of the SNS-110 uses the RS-442/485 interface and

PAN/TILT/ZOOM/FOCUS controllers can be connected to the terminal.

The PAN/TILT/ZOOM/FOCUS controllers that are supported are the following.

● Samsung Smart-Dome Camera (SCC-641) ● Pelco : Pelco-P Protocol Support Control

● Sungjin Electronic Communications : CPU-Receiver

The TX+ and TX- of the terminal as shown in picture, is connected to the external terminal of the

PAN/TILT/ZOOM/FOCUS controller, and generally the external terminal has a +,- polarity indication so be

sure not to switch the polarity.

Set the F/H Switch to On (knob faced down) on the front side of the SNS-110.

Refer to the PAN/TILT/ZOOM/FOCUS controller manual and confirm & reset the following items.

● Baud Rate ● Data Bit

● Stop Bit ● Parity Bit

● Controller ID (be careful not to duplicate a different controller ID)

ALARM IN

R/O

1 2 3 4 - + - +

P/T/Z/F Controller 1

P/T/Z/F Controller 2

P/T/Z/F Controller 3

P/T/Z/F Controller 4

When connecting Samsung Smart-Dome Camera (SCC-641), you have to connect the

SNS-110 to the TxDt, - terminals of SCC-641. In this case, the supportable Baud Rate

is 38400 and 19200bps. For more detail information, please refer to the user manual

of SCC-641.

Reference inquire the shop at which it was purchased for the products other

that the above PAN/TILT/ZOOM/FOCUS camera and controllers.

Note

RX-

RX+

RX-

RX+

RX-

RX+

RX-

RX+

If several PAN/TILT/ZOOM/FOCUS controllers are used, they must be the same

models.

Caution

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 88 89

Sin comentarios

Samsung Version 1.1 Manual de usuario Pagina 19