Samsung SMM-PIRCAM Manual de instalación descargar pdf (Pagina 22)

1-4. Basic System Installation

Perform the following steps to install your system.

●

Take the monitor out of the packaging box.

●

Place the monitor where you would like to install it. Do not turn on power until

installation is complete

●

Choose the place where you want to install the camera.

●

Once the monitor and camera locations have been chosen, install the camera.

●

Connect the cable to the jack on the back of the camera.

●

Connect the other end to CAMERA IN on the back of the monitor.

(At this time, select the numbers and sequence of cameras.)

●

Connect the camera you wish to install (as shown below).

●

Connect the power cord of the monitor to the power outlet.

●

Power switch is on the rear panel of the monitor, and screen on switch is on the front

panel of the monitor.

●

Initially the monitor is in the auto switching mode.

✳ After the power has been turned on, the CRT needs approximately 20 seconds of

stabilization period.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Sin comentarios

Samsung SMM-PIRCAM Manual de instalación Pagina 22