Samsung CS-25M21MA Manual de usuario

Quick Facts and Workarounds for Samsung 1000 1. Issue: On VPN orders the Wizard does not complete the config. We need to remove the DNS requests in

Yellow Alarm: DISABLE Framing:ESF, LineCode:B8ZS, ClockSource:line, LineMode:CSU, LBO:0 db FDL: ANSI Unit Protocol enabled ,ATT Unit Protocol disabled

Off Router is not receiving power. P0 ~ P3 (T1/E1) Solid green T1/E1 port is operating normally. Solid red T1/E1 port cable is not connected pro

These are Old Issues that are Resolved but you might find an older CPE with them. 1. Issue: Samsung 1000s are coming with a T-1 or regular cross

3. Issue: You can’t surf unless you put DNS numbers into your lap top on a circuit using Covad PPP information and IPs. As you know, on Covad PPP cir

exit t1 module t1 0/2 clock_source line

ataDriveInit0/0 error: state=1 sdh=0x0 status=0x50 error=0x1 ataDrv error: 0xffffffff [ATA] Error: usrataDrv() init failure Error: Can't init

Script Clarification: See the order below. You will notice that this is a BZN VOAN circuit. The information on the bottom left hand corner of the or

11. Issue: Script clarification- One of the commands tells the CPE which IPs to exclude from the DHCP pool. You only need to exclude the IP for the

# [LAN_VOICE_NET] = the network prefix of the LAN voice interface 13. Issue: After configuring the CPE you continue to see output from the CPE. Thi

Unlock the CPE wizard and change the DLCI from 18 to 16 on the configuration tab. Note: reports state that this is the only change needed. If it

7. The CPE takes a few minutes to sync and authenticate. Give it a few extra minutes before you worry about troubleshooting. 8. Single T1's wo