Samsung Epic 4G Manual de usuario

Samsung Epic 4G Touch Front PanelAssembly ReplacementReplace the front panel assembly on your Samsung Epic 4G Touch.Written By: Sam LionheartINTRODUCT

Step 15 — Motherboard Assembly Use the flat end of a spudger to disconnect the front-facing camera cable connector.Step 16Carefully disconnect the di

Step 17Use a spudger to disconnect thedisplay cable connector.Step 18Remove the two 3 mm Phillips #00screws.Samsung Epic 4G Touch Front Panel Assemb

Step 19 Lift the micro-USB end of the motherboard away from the display assembly and pull itdown.Be mindful that you don't snag the motherboar

Step 21 — Front Facing Camera/Earpiece Speaker AssemblyRemove the 2.3 mm Phillips #00screw securing the front-facingcamera bracket to the displayassem

Step 23 Using a pair of tweezers, or your fingers, remove the front-facing camera/earpiecespeaker assembly.Step 24 — Headphone Jack/Vibrator Insert t

Step 25Use the flat end of a spudger torelease the headphone jack fromthe adhesive securing it to themidframe.Step 26Remove the headphonejack/vibrato

To reassemble your device, follow these instructions in reverse order.This document was last generated on 2015-05-05 03:30:13 AM.Step 27 — Front Panel

Step 1 — Rear Case Insert a plastic opening tool, or your fingernail, into the opening near the left side of theheadphone jack.Pry the opening tool d

Step 3 — microSD Card Use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeperinto its slot until you hear a click

Step 5 — Battery Wedge a plastic opening tool into the crevice between the battery and midframe locatednear the bottom left corner.Push the plastic o

Step 7 — Plastic MidframeRemove the six 4.0 mm Phillips#00 screws securing the midframeto the front panel assembly.Samsung Epic 4G Touch Front Panel

Step 8 Unless you pry at the right insertion points, you might have a difficult time removing themidframe. This shot of the display assembly, with dis

Step 9 Insert a plastic opening tool slightly to the left of the micro-USB port, and pry between themidframe and the display to open a gap.Step 10 We

Step 11 Pry again about two inches to the right of the volume control toggles between the midframeand the front panel assembly.Step 12 Pull the micro

Step 13 — Motherboard ConnectorsHeadphone jack/vibrator assemblycable connectorFront-facing camera cableconnectorDigitizer cable connectorDisplay c