Samsung HG40EC890 Manual de instalación descargar pdf (Pagina 31)

English

¦ Multi Code Remocon

Multi Code Remocon is a special transmitter which is designed to control each TV with one remote.

This is useful where there is more than one TV in a location, such as in a hospital the set ID number is displayed in the source

osd. It is possible to support up to 9 different remote key transmissions for multiple codes.

Each TV has an initial code of "0".

– The ID code can be set and reset in Analog TV mode or PC mode. (not available in TTX channel or DTV channel.

– ID code can be from 0 to 9.

– Press the Blue Key for over 7 seconds and then select the number button to set the code.

– Set ID OSD appears.

– The following words appear: “Remote control code is set to x. If you want to change Remote control code. Enter the

digit you want to change.” X is the digit number This OSD displays until Exit is pressed.

Remote control code is set to 0. If you want

to change the Remote control code, enter the

chosen digit.

– For example, TV and Remote will be set to ID code #1 if the user presses #1.

– The following words appear: “Remote control code is changed to 1” At this point, the TV can be controlled only by the

remote with the same ID code as the TV.

– TV, the following words will be displayed. “ TV ID x”(x is the TV’s ID)

– To reset the ID code, press the Yellow key for over 3 seconds. the ID code for both the TV and Remote are reset to “0”.

“Remote control code is set to 0.” appears.

[HC890-EU]Install Guide-X0ENG.indd 31 2014-05-22  4:37:16

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 64 65

Sin comentarios

Samsung HG40EC890 Manual de instalación Pagina 31