
GB 20
3.6 Cleaning and maintenance
Remove the burner caps, burner head and burner ring by pulling them upwards and ■
away from the top plate.
Soak them in hot water and a little detergent. ■
After cleaning and washing them, wipe and dry them carefully. Make sure that the ■
fl ame holes are clean and completely dry.
Wipe the fi xed parts of the burner base with a damp cloth and dry afterwards. ■
Gently wipe the thermocouple and spark plug with a well wrung-out cloth and wipe ■
dry with a clean cloth
Make sure that the injector is not blocked before placing the burners back on the top ■
plate.
Burners
Assemble the auxiliary, semi-rapid, rapid and wok burners
as follows
Replace the burner head (12) by ensuring that the locating tabs fi t
into the notches in the burner base (14).
Place the burner head (12) on the burner ring (13) so that the
thermocouple (15) and the spark plug (16) extend through their
respective holes in the burner head.
Replace the burner cap (11) by ensuring that the locating tabs fi t
into the notches in the burner base (14).
Replace parts in the correct order after cleaning
Do not mix up the top and bottom. ■
The locating lugs must fi t exactly into the notches. ■
Set the pan supports down vertically without sliding ■
them over the spillage well.
11
12
12
13
15
15
16
16
14
14
IT 13
3.1 Descrizione del piano di cottura
Vassoio di raccolta dei liquidi1.
Bruciatore ausiliario2.
Bruciatore semi-rapido3.
Bruciatore rapido4.
Bruciatore wok5.
Manopola di controllo6.
Griglia di supporto7.
Manopola di regolazione8.
Anello di guarnizione9.
Rubinetto10.
Coperchio del bruciatore11.
Testa del bruciatore12.
Anello del bruciatore13.
Coppa del bruciatore14.
Termocoppia15.
Candela di accensione16.
Manopola Bruciatore
(ausiliario, semi-rapido, rapido e wok)
8
9
10
11
12
12
13
1515
1616
14
14
GN952IFXA / GN952IFXAB
1
66666
7
2
3534
Comentarios a estos manuales