Samsung CTR364T007 Instrucciones de operaciones descargar pdf (Pagina 7)

Installing the Hob

Important: Be sure the new appliance is installed and grounded only by qualied

personnel

Please observe this instruction The warranty will not cover any damage that may

occur as a result of improper installation

Technical data is provided at the end of this manual

Regulations and compliance

This appliance meets the following standards:

• EN 60 335 - 1 and EN 60 335 - 2 - 6, relating to the safety of electrical appliances for house-

hold use and similar purposes;

• EN 60350, or DIN 44546 / 44547 / 44548, relating to the operating features of electric cook-

ers, hobs, ovens, and grills for household use;

• EN 55014 - 2;

• EN 55014;

• EN 61000 - 3 - 2; and

• EN 61000 - 3 - 3, relating to basic requirements for electromagnetic compatibility (EMC)

This appliance complies with the following EU Directives:

• 73 / 23 / EWG dated 19021973 (Low Voltage Directive);

• 89 / 336 / EWG dated 03051989 (EMC Directive including Amending Directive 92

/ 31 / EWG); and

• 93 / 68 / EWG CE Labeling Directive

Safety instructions for the installer

• A device must be provided in the electrical installation that allows the appliance to be discon-

nected from the mains at all poles with a contact opening width of at least 3 mm Suitable

isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed

from the holder), earth leakage trips and contactors

• With respect to re protection, this appliance corresponds to EN 60 335 - 2 - 6 This type of

appliance may be installed with a high cupboard or wall on one side

• Drawers may not be tted underneath the hob

• The installation must guarantee shock protection

• The kitchen unit in which the appliance is tted must satisfy the stability requirements of DIN

68930

• For protection against moisture, all cut surfaces are to be sealed with a suitable sealant

• On tiled work surfaces, the joints in the area where the hob sits must be completely lled with

grout

• On natural, articial stone, or ceramic tops, the snap action springs must be bonded in place

with a suitable articial resin or mixed adhesive

• Ensure that the seal is correctly seated against the work surface without any gaps Additional

silicon sealant must not be applied; this would make removal more difcult when servicing

• The hob must be pressed out from below when removed

CTR364N016_SLI-00083A-02_EN.indd 5 05/05/2011 16:00:11

1 2 3 4 5 6 7 8 9 10 11 12 ... 63 64

Sin comentarios

Samsung CTR364T007 Instrucciones de operaciones Pagina 7