Samsung C61R2AEE Manual de usuario

Installation and Operating Instructions Ceramic Glass HobC61RAAST / C61RABAL / C61RACN / C61RADST C61RAEE / C61R1AAMST / C61R1ABMAL / C61R1ACMN C61R1A

8ENInstalling the Hob (Continued)x4902100100490+1==C Top_MID] C61RAAST_XEU-00031A-03_EN.indd 8 26/10/2555 14:46:16

9ENParts and FeaturesCooking zones and control panel148 mm148 mm183 mm183 mmSingle cooking zone 1200 WSingle cooking zone 1800WSingle cooking zone 120

10ENComponents1 Ceramic Glass Hob2 Installation Brackets3 ScrewsParts and Features (Continued)C Top_MID] C61RAAST_XEU-00031A-03_EN.indd 10 26/10/255

11ENParts and Features (Continued)The key features of your appliance• Ceramic glass cooking surface: The appliance has a ceramic glass cooking surfac

12ENParts and Features (Continued)Safety shutoffIf one of the cooking zones is not switched off or the heat setting is not adjusted after an ex-tended

13ENHob UseUsing suitable cookwareBetter pans produce better results.• You can recognise good pans by their bases. The base should be as thick and a

14ENHob Use (Continued)• Always position pots and pans before switching on the cooking zone.• Dirty cooking zones and pan bases increase power consump

15ENHob Use (Continued)Switching the appliance onTouch the “Lock ” sensor for approximately 3 seconds.The appliance is switched on using the “On / Of

16ENHob Use (Continued)Switching the appliance offTo completely switch off the appliance, use the “On / Off ” control sensor.Touch the “On / Off ” s

17ENUsing the child safety lockYou can use the child safety lock to safeguard against unintentionally turning on a cooking zone and activating the coo

C Top_MID] C61RAAST_XEU-00031A-03_EN.indd 2 26/10/2555 14:46:16

18ENHob Use (Continued)Switching the child safety lock off1. Touch the control sensor for approximately 3 seconds. An acoustic signal will sound as c

19ENHob Use (Continued)Locking and unlocking the control panelAt any stage during the cooking process, the control panel, with the exception of the “O

20ENCleaning and CareHob Important: Cleaning agents must not come into contact with a heated ceramic glass surface: All cleaning agents must be r

21ENProblem Dirt1. Remove burnt-on sugar, melted plastic, aluminium foil or other materials with a glass scraper immediately and while still hot. I

22ENWarranty and ServiceFAQs and troubleshootingA fault may result from a minor error that you can correct yourself with the help of the following ins

23ENWarranty and Service (Continued)What does it mean when the burner does not glow red?• The selected temperature of the cooking zone is maintained

24ENTechnical Data CORRECT DISPOSAL OF THIS PRODUCT (WASTE ELECTRICAL & ELECTRONIC EQUIPMENT) (Applicable in countries with separate collection sy

25Technical Data (Continued)Product InformationSupplier’s name Samsung Electronics co. Ltd.C61R2AASTC61R2AEEC61R2AEEPCTR464EB01C61R1AAMSTType of hob B

C Top_MID] C61RAAST_XEU-00031A-03_EN.indd 26 26/10/2555 14:46:18QUESTIONS OR COMMENTS?COUNTRY CALL OR VISIT US ONLINE ATAUSTRIA0800-SAMSUNG (0800-

1ENContentsUsing This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Safety .

2ENUsing This ManualPlease take the time to read this owner’s manual, paying particular attention to the safety information contained in the following

3ENSafety The safety aspects of this appliance comply with accepted technical standards and the German Appliance Safety Law. However, as manufacture

4ENSafety during use• This appliance is to be used only for normal cooking and frying in the home. It is not de-signed for commercial or industrial u

5ENInstalling the Hob Important: Be sure the new appliance is installed and grounded only by qualied personnel. Please observe this instruction.

6ENInstalling the Hob (Continued)Connecting to the mains power supplyBefore connecting, check that the nominal voltage of the appliance, that is, the

7ENInstalling the Hob (Continued)Installing into the countertop Make a note of the serial number on the appliance rating plate prior to installation